• First Aid
In the type of work that mechanics are engaged in, dirt, grease, fine dusts, etc., all settle upon the skin and
clothing. If a cut, abrasion or burn is disregarded it may be found that a septic condition has formed within
a short time. What appears at first to be trivial could become painful and injurious. It only takes a few minutes
to have a fresh cut dressed, but it will take longer if you neglect it. Make sure you know where the First Aid
box is located.
• Cleanliness
Cleanliness of the tractor hydraulic system is essential for optimum performance. When carrying out service
and repairs plug all hose ends and component connections to prevent dirt entry.
Clean the exterior of all components before carrying out any form of repair. Dirt and abrasive dust can reduce
the efficiency and working life of a component and lead to costly replacement. Use of a high pressure washer
or steam cleaner is recommended.
OPERATIONAL CONSIDERATIONS
• Stop the engine, if at all possible, before performing any service.
• Place a warning sign on tractors which, due to service or overhaul, would be dangerous to start. Disconnect
the battery leads if leaving such a unit unattended.
• Do not attempt to start the engine while standing beside the tractor or attempt to by-pass the neutral start switch.
• Avoid prolonged running of the engine in a closed building or in an area with inadequate ventilation as exhaust
fumes are highly toxic.
• Always turn the radiator cap to the first stop to allow pressure in the system to dissipate when the coolant is hot.
• Never work beneath a tractor which is on soft ground. Always take the unit to an area which has a hard working
surface - concrete for preference.
• If it is found necessary to raise the tractor for ease of servicing or repair, make sure that safe and stable supports
are installed beneath axle housings, casings, etc., before commencing work.
• Certain repair or overhaul procedures may necessitate "separating the tractor," either at the engine/front transmis-
sion or front transmission/rear transmission locations. These operations are simplified by the use of the Tractor
Splitting Kit/Stands. Should this equipment not be available, then every consideration must be given to stabili-
ty, balance and weight of the components, especially if a cab is installed on the tractor.
• Use footsteps or working platforms when servicing those areas of a tractor that are not within easy reach.
• Before loosening any hoses or tubes connecting implements to remote control valves, etc., switch off the engine,
remove all pressure in the lines by operating levers several times. This will remove the danger of personal injury
by oil pressure.
• Prior to pressure testing, make sure all hoses and connectors not only of the tractor, but also those of the test
equipment, are in good condition and tightly sealed. Pressure readings must be taken with the gauges specified.
The correct procedure should be rigidly observed to prevent damage to the system or the equipment, and to
eliminate the possibility of personal injury.
• When equipment or implements are required to be attached to the hydraulic linkage, either for testing purposes
or for transportation, then "position control" should be used.
• Always lower equipment to the ground when leaving the tractor.
• If high lift attachments are installed on a tractor beware of overhead power, electric or telephone cables when
traveling. Drop attachment near to ground level to increase stability and minimize risks.
PRINTED
IN U.S.A.
vii
Find manuals at https://best-manuals.com
To Next Page
Loading...