84
special torque chart (reference only)
FIGURE B: Flywheel Bolts
Step 1: Torque the bolts to 44 lbf/in (5 Nm) in
the numerical sequence shown.
Step 2: Torque the bolts to 69 lbf/ft (94 Nm) in the
numerical sequence shown above.
Note: Flywheel bolts may not be reused once torqued.
FIGURE C: Bedplate Bolts (main bearing bolts)
Step 1: Torque the bolts to 110 lbf/ft (149 Nm)
in the numerical sequence shown.
Step 2: Torque the bolts to 130 lbf/ft (176 Nm)
in the numerical sequence shown.
Step 3: Torque the bolts to 170 lbf/ft (231 Nm)
in the numerical sequence shown.
FIGURE A: Cylinder Head Bolts
Step 1: Lightly lubricate M16 head bolt threads and washer
faces with clean engine oil prior to assembly.
Step 2: Torque M16 head bolts (labeled 1-10) to 70
lb/ft (95 Nm) in numerrical sequence shown.
Step 3: Back out M16 head bolts and retorque to 115 lb/ft
(156 Nm) one at a time in numerical sequence shown.
Step 4: Tighten M16 head bolts and additional 90
degrees in numerical sequence shown.
Step 5: Tighten M16 head bolts an additional 90 degrees
(2nd time) in numerical sequence shown.
Step 6: Torque M8 head bolts (labeled 11-15) to 18
lb/ft (24 Nm) in numerical sequence shown.
Step 7: Torque M8 head bolts to 23 lb/ft (31 Nm)
in numerical sequence shown.
Note: Head bolts may not be reused once torqued.
Note: If bolt chatter occurs during step
4, repeat step 3 and continue.
To Next Page
Loading...
