Ford 6.4L Power Stroke - Exhaust Manifold Bolts; Vibration Damper Bolts; Intake Manifold Bolts

85
special torque chart (reference only)
FIGURE D: Intake Manifold Bolts
Step 1: Loosely install all bolts in the
numerical sequence shown.
Step 2: Torque bolts to 100 lb/in (11Nm) in
the numerical sequence shown.
Note: Bolt locations with double circles represent stud bolts.
FIGURE E: Vibration Damper Bolts
Step 1: Torque each bolt to 50 lb/ft (68 Nm) in
the numerical sequence shown.
Step 2: Tighten each bolt 90 degrees clockwise
in the numerical sequence shown.
Note: Damper bolts may not be reused once torqued.
FIGURE F: Exhaust Manifold Bolts
Step 1: Torque bolts to 18 lb/ft (25Nm) in the
numerical sequence shown.
Step 2: Repeat the sequence using the same torque.
Note: Exhaust manifold bolts and studbolts
may not be reused once torqued.