14
FORD MODEL A
Lubrication of the Clutch Bearing
The clutch pilot bearing at the front end of the clutch is
thoroughly packed
with grease when the car is assembled, and
it will not be necessary to lubricate this bearing until such time
as the clutch may be disassembled. When the clutch is disas-
sembled the bearing should be repacked with a good grade of
cup grease.
Approximately every 2000 miles , lubricate the clutch release
bearing. This is done by remo ving the hand hole cover and
turning the bearing until the lubricator fitting is at the top.
Lubricate the bearing by means of the compressor grease gun.
NOTE: The clutch is a
dry disc clutch and under no cir-
cumstances ·should it be oiled.
To Next Page
Loading...
