4. Remove the cover to access the rear
fastener.
5. Using the supplied special tool, loosen
the fastener until you can remove the
rack.
6. Remove the rack from the vehicle.
Note: The windshield trim cover, retaining
plate and fasteners are provided. The trim
cover is installed when you remove the roof
rack.
7. Locate the trim cover components.
8. Place the trim cover retaining plate
over the mounting studs.
9. Install the supplied fasteners. Torque
nuts to 7.7 lb.ft (10.5 Nm).
10. Align the cover with the alignment
slot at the front of the cover, then
rotate rearward and snap into place.
Installing the Roof Rack
1. To remove, press the button on the rear
of the trim cover and rotate forward.
2. Remove the fasteners and remove the
trim cover retaining plate.
3. Store the trim cover components.
4. Position the roof rack on the vehicle.
5. Hand start the front roof rack fasteners.
6. Using a 10 mm socket, tighten the front
roof rack fasteners. Torque bolts to
7.7 lb.ft (10.5 Nm).
7. Align the cover with the alignment slot
and rotate rearward.
8. Hand start the front roof rack cover
fasteners.
9. Using the provided T30 tool, tighten
the front roof rack cover fasteners.
Torque bolts to 5.9 lb.ft (8 Nm).
277
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Load Carrying
To Next Page
Loading...
