Note: The rear crossbar is part of the
clamping system. If you removed the
crossbar you must install it first for proper
attachment to the hard top.
10. Using the supplied special tool,
tighten the fastener.
Note: The supplied special tool stops
turning the fastener when you have proper
torque applied.
11. Install the rear roof rack fastener
cover.
ADJUSTING A ROOF RACK
CROSSBAR
Adjusting the Crossbar (If Equipped)
1. Using the provided T30 tool, remove
the crossbar bolts.
2. Move the crossbar to the new position.
3. Using the provided T30 tool, install the
crossbar bolts.
Note: Torque bolts to 5.9 lb.ft (8 Nm).
Note: Moving the crossbars forward may
increase wind noise. To limit wind noise
return the crossbars to the rearward
position.
ROOF RACK LOAD CAPACITIES
Maximum Recommended Load Amounts
Maximum Recommended LoadDescription
110 lb (50 kg)When in motion
450 lb (204 kg)When stationary
278
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Load Carrying
To Next Page
Loading...
