7. Remove the three retaining bolts
securing the rear lamp to the body.
Note: Remove and install the retaining bolt
near the wheel well before the retaining
bolts near the luggage compartment.
8. Pull the rear lamp away from the
vehicle and disconnect the electrical
connectors as needed.
9. To install, reverse the removal
procedure.
CHANGING A REAR LAMP BULB
Stoplamp, rear and turn signal
bulb.
A.
Reversing lamp bulb.B.
1. Remove the rear lamp assembly. See
Removing a Rear Lamp Assembly
(page 335).
2. Rotate the bulb socket
counterclockwise and remove it from
the rear lamp assembly.
3. To install, reverse the removal
procedure.
INTERIOR BULBS
INTERIOR BULB SPECIFICATION
CHART
Your vehicle has LED lamps. These are not
serviceable items. See an authorized dealer
if they fail.
DRIVE BELT ROUTING - 2.3L
ECOBOOST™
Short drive belt is on the second
pulley groove farthest from
engine.
A.
Long drive belt is on the first
pulley groove closest to engine.
B.
336
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Maintenance
To Next Page
Loading...
