12. Gently close the door to the fully
closed position and make sure that
the bumper is under slight
compression. If the bumper is not
slightly compressed while the door is
in the fully closed position, adjust the
bumper as needed.
Note: To avoid body damage, do not slam
the door until the bumper adjustments are
finalized.
13. Open and close the installed door a
few times to make sure it is properly
aligned and that it operates normally.
14. To install additional doors, repeat
steps 3-13.
15. Return the hex tool and door
alignment pin to the tool kit and
secure the tool kit in the vehicle’s
center console.
16. Return the mirrors to the driving
position.
Note: Rear seat occupant alert does not
function with tube doors.
Latch Alignment Adjustments
Vertical Adjustments
To make vertical adjustments:
1. Loosen the upper and lower hinge
mounting bolts.
2. Engage the latch on the striker to make
sure it is properly aligned.
3. Tighten the upper and lower hinge
mounting bolts, but do not apply final
torque.
4. Disengage and reengage the latch from
the striker and confirm proper
alignment.
5. Tighten the upper and lower hinge
mounting bolts to 41 lb.ft (55 Nm).
Horizontal Adjustments
To make horizontal adjustments:
348
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Removable Vehicle Components
To Next Page
Loading...
