1. Loosen the upper and lower hinge
mounting bolts.
2. Add or remove shims as necessary to
attain proper latch alignment, start
with no shims.
3. Tighten the upper and lower hinge
mounting bolts, but do not apply final
torque.
4. Disengage the latch from the striker
and confirm proper alignment.
5. Tighten the upper and lower hinge
mounting bolts to 41 lb.ft (55 Nm).
Removing the Doors
WARNING: Removal of doors for
off-road use only. Removing the doors
from the vehicle will affect protection
provided by the doors and may affect
safety system performance, including
safety canopy and front seat mounted
side airbags, during a crash or rollover.
1. Switch your vehicle off.
2. Fold the mirrors completely toward the
front of your vehicle before removing
the front doors.
3. Fully open the door you are removing.
4. Use the provided hex tool to loosen
and remove the lower hinge bolt.
5. Loosen and remove the upper hinge
bolt.
Note: You can store the hinge bolts in the
tool pouch zipped pocket, if needed.
6. Lift the door vertically to separate it
from the vehicle.
Note: Use caution when removing the doors
as they are heavy.
Note: Store the doors in a secure area.
Note: Store the doors out of the elements
to prevent damage.
7. To remove additional doors, repeat
steps 3-6.
8. Return the hex tool to the tool kit and
secure the tool kit in the vehicle’s
center console.
9. Return the mirrors to the driving
position.
Note: When you remove the doors, the rear
seat occupant alert no longer functions.
Cleaning the Tube Doors
We recommend that you wash the tube
doors with mild soap and rinse with a
standard pressure water hose. While
rinsing, avoid spraying water directly onto
the latch mechanism. Dry with a microfiber
cloth or leave to air dry.
DOORS AND LOCKS AUDIBLE
WARNINGS
Sounds when a door is not fully closed or
removed and your vehicle is moving.
349
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Removable Vehicle Components
To Next Page
Loading...
