7. Secure the wiring harness to the body
side by plugging it into the receptacle
and pushing up on the locking tab.
8. Secure the washer hose by snapping it
into the top of the body side
receptacle.
9. Remove the four fasteners on each side
of your vehicle that secure the rear roof
panel to the vehicle using the provided
head driver and ratchet.
10. With the tailgate window open, grab
the opening with one hand and
slightly lift with the other hand. Lift
the rear roof panel straight up and
off. Place the rear roof panel on a soft
surface to prevent damage.
Note: Store the rear roof panel with the
tailgate window open to prevent damage
to the glass seal.
11. To install, reverse the removal
procedure. Torque the fasteners that
secure the rear roof panel to your
vehicle to 15 ± 2 lb.ft (20 ± 3 Nm).
Note: Make sure the locating pins on the
rear roof panel sit flush in your vehicle when
installed.
Note: Do not overtighten the fasteners. You
can strip the fasteners if they are
overtightened.
REMOVING AND INSTALLING THE
REAR ROOF PANEL - 4-DOOR
Remove the front panels and center panel
before removing the rear roof panel.
1. Open the rear doors.
2. Open the tailgate window. See
Opening and Closing the Windows
(page 103).
3. Locate the wire harness and washer
hose on the driver side rear inside
corner of the vehicle.
4. Release the locking tab by pushing it
down.
To Next Page
Loading...
