When washing the engine compartment:
• Never wash or rinse the engine while it
is hot or running.
• Never wash or rinse any ignition coil,
spark plug wire or spark plug well.
• Cover the battery, power distribution
box, and air filter assembly to prevent
water damage.
Note: If your vehicle has an engine cover
remove the cover before application of
shampoo and degreaser.
• Spray an approved engine shampoo
and degreaser on all parts that require
cleaning and rinse with water.
CLEANING THE CONVERTIBLE
TOP
Remove lint with a lint roller or vacuum
with a soft bristle brush.
Wash with an approved high quality
convertible top cleaner and protectant.
Note: Do not use stiff bristle brushes,
abrasive materials or household cleaning
products.
Note: High pressure water may cause water
leaks and possible seal damage to the
convertible top.
Cleaning the Soft Top Windows
We recommend that you only clean the
soft top windows in the following way:
1. Use only a microfiber cloth, cold or
lukewarm water, and a mild soap and
water solution to clean the soft top
windows in a circular motion.
2. Rinse thoroughly with cold water, then
wipe with a soft, damp cloth.
3. Use a small amount of soft top window
cleaner or equivalent to remove fine
scratches and to improve visibility and
provide UV protection to help prevent
yellowing.
4. For additional information and
assistance, we recommend that you
contact an authorized dealer.
Note: Test any cleaner on an inconspicuous
area before applying broadly.
Note: Do not use hot water or anything
stronger than mild soap on the soft top
window.
Note: Do not use solvents such as alcohol
or harsh cleaning agents on the soft top
window.
Note: Do not use a scraper or de-icing
chemicals to remove frost, snow, or ice. Use
warm water only.
Note: Do not paste stickers, gummed labels
or any tape on the soft top window surface.
CLEANING STRIPES OR
GRAPHICS
It is recommended to wash your vehicle by
hand however, pressure washing may be
used under the following conditions:
• Use a spray with a 40° wide spray
angle pattern.
• Keep the nozzle at a 12 in (305 mm)
distance and 90° angle to your
vehicle's surface.
• Do not use water pressure higher than
2,000 psi (14,000 kPa).
• Do not use water hotter than 179°F
(82°C).
Note: Holding the pressure washer nozzle
at an angle to the vehicle's surface may
damage graphics and cause the edges to
peel away from the vehicle's surface.
CLEANING CAMERA LENSES AND
SENSORS
We recommend that you only use
lukewarm or cold water and a soft cloth
to clean the camera lens and sensors.
370
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Vehicle Care
To Next Page
Loading...
