WARNING: Always fully apply the
parking brake. Failure to follow this
instruction could result in personal injury
or death.
WARNING: The jack should be
used on level firm ground wherever
possible.
Note: Make sure all passengers are out of
your vehicle.
Note: Jack at the specified locations to
avoid damage to the vehicle.
Note: No maintenance or additional
lubrication of your jack is required over the
service life of your vehicle.
1. Park the vehicle on a level, firm surface
and activate the hazard flashers.
2. Apply the parking brake, and place the
transmission in park (P) for an
automatic transmission or reverse (R)
for a manual transmission and turn the
engine off.
3. Block the wheel diagonally opposite of
the flat tire. For example, if the left
front is flat, block the right rear wheel.
4. Find the jack and tool kit in the rear
trunk of the vehicle. Turn the jack
retainer counterclockwise to remove
the jack and jack extension block.
396
2022 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Changing a Road Wheel
To Next Page
Loading...
