14
HANDS-FREE POWER LIFTGATE
*
Open Your Ligate Hands-free While You Are at the Ligate
Move your leg toward and under, then away from the rear bumper
(similar to a kicking motion). The ligate will power open or close.
Note Your intelligent access key must be within 3 feet
(1 meter) of the ligate for the “hands-free” open feature
to work. The ligate will not power open or close under specific
conditions. Refer to the Locks chapter in your Owner’s Manual
for more information.
SETTING THE LIFTGATE OPEN HEIGHT
*
To Change Your Ligate Opening Height
1. Open the ligate.
2. Manually move the ligate to the desired height.
3. Press and hold the control button on the ligate until you
hear a tone, indicating the new height has been programmed.
The new open ligate height will now be recalled when the
power ligate is opened.
4. To change the programmed height, repeat the above
procedure. Once the power ligate is opened, it can be
manually moved to a dierent height.
MANUAL LIFTGATE
To open the ligate manually from outside of your vehicle, press
the button located in the top of the ligate pull cup handle to
unlatch the ligate, and then pull on the outside handle.
You can also use the remote control to open your ligate. Press
the
button twice within three seconds.
Use the molded handle inside the ligate to help with closing.
POWER LIFTGATE
*
You can open the power ligate from the instrument panel by
pressing the
button, or with the remote control by pressing
the
button.
If the vehicle is running, the ligate will only operate with the
transmission in P (Park). Three warning tones will sound once as
the ligate begins to power close.
Five short tones indicate a problem
with the open or close request,
caused when:
» the ignition is on and the
transmission is not in P (Park)
» the battery voltage is below the
minimum operating voltage
» or the vehicle speed is at or
above 3 mph (5 km/h).
convenience
*if equipped
15
function
INTELLIGENT ACCESS
*
Note Your intelligent access key must
be within 3 feet (1 meter) of the vehicle for
intelligent access to function properly.
To unlock the driver’s door: Pull the front
exterior door handle. Touch the raised sensor on
the driver’s door handle to lock your vehicle.
To unlock and open the liftgate: Press the
exterior ligate release button near the license
plate. The intelligent
access key also contains
a mechanical key blade,
which can be used to
unlock the driver’s door
if necessary. For complete
information, refer to
the Keys and Remote
Control chapter in your
Owner’s Manual.
REMOTE START
To Remote Start Your Vehicle
1. Press the lock button to lock all the doors.
2. Press the remote start button twice. The exterior lamps will flash twice.
Note If you remote start your vehicle with an integrated keyhead transmitter, you
must switch the ignition on before driving your vehicle. If you remote start your vehicle
with an intelligent access transmitter, you must press the START/STOP button on the
instrument panel once while applying the brake pedal before driving your vehicle. For
complete information, refer to the Remote Control chapter in your Owner’s Manual.
MYKEY
®
MyKey allows you to program certain driving restrictions in order to promote good
driving habits. You can program things like: speed restrictions, limited volume levels
and safety belt reminders. For complete information, refer to the MyKey chapter in
your Owner’s Manual.
110-VOLT AC POWER POINT
*
The power point is located on the rear of the center
console and can be used to power your smaller electrical
devices that do not exceed 150 watts. This feature is
available to use when your ignition is turned on and the
battery voltage is above 11 volts. When the indicator light
is on, the power point is working and ready to use.
CARGO STORAGE
Your vehicle is equipped with two under-floor storage
compartments that are located behind the front seats. You
can use these compartments to store smaller items discretely.
With the lids secured, your items will stay in place while
you drive.
*if equipped