The electric windows will stop
automatically while closing and
reverse some distance if there is an
obstacle in the way.
Overriding the anti-trap
function
CAUTION
While you close the window for
the third time, the anti-trap
function is disabled. Make sure there
are no obstacles in the way of the
closing window.
To override this protection function
when there is a resistance, e.g. in the
winter, proceed as follows:
1. Close the window twice until it
reaches the resistance and let it
reverse.
2. Close the window a third time to
the resistance. The anti-trap
function is disabled and you
cannot close the window
automatically. The window will
override the resistance and you
can close it fully.
3. If the window does not close after
the third attempt, have it checked
by an expert.
Resetting the memory of
the electric windows
WARNING
The anti-trap function is
deactivated until you have reset
the memory.
After the battery has been
disconnected from the vehicle you
must reset the memory separately
for each window:
1. Lift and hold the switch until the
window is fully closed.
2. Release the switch.
3. Lift the switch again for one more
second.
4. Push and hold the switch until the
window is fully open.
5. Release the switch.
6. Lift and hold the switch until the
window is fully closed.
7. Open the window and try to close
it automatically.
8. Reset and repeat procedure if the
window does not close
automatically.
EXTERIOR MIRRORS
Convex mirrors
To Next Page
Loading...
