REMOVING A HEADLAMP
1. Open the hood. See Opening and
Closing the Hood (page 127).
2. Remove the screws and push pins.
3. Lift the outer side of the headlamp to
disengage it from the lower fixing point.
4. Pull the headlamp as far as possible
toward the center of your vehicle and
remove.
5. Disconnect the two electrical
connectors.
Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector correctly.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the lower fixing point.
BULB SPECIFICATION CHART
Power (watt)SpecificationLamp
21PY21WFront direction indicator
55 / 60WH4Headlamp main beam / dipped beam
55H11Front fog lamp
5WY5WSide repeater
21PY21WRear direction indicator
21/5P21/5WBrake and tail lamp
21P21WRear fog lamp
21P21WReversing lamp
142
Ecosport (CBW)
Maintenance
To Next Page
Loading...
