Ford ECOSPORT 2014 - Changing a Bulb

WARNING
You must replace the battery with
one of exactly the same
specification.
Note: For vehicles with a manual
transmission, if the battery goes flat or you
install a new battery, the engine will not
start until you press and hold the clutch
pedal down for two seconds then release
the clutch pedal and wait two seconds with
the key turned to the on position and the
engine is off.
The battery is located in the engine
compartment. See Maintenance (page
116).
To remove and install the battery:
Note: Do not loosen the powertrain control
module from the bracket.
Note: Do not disconnect the powertrain
control module from the connector.
E164689
1. Remove the two screws from the
powertrain control module cover.
E164690
2
3
2. Remove the negative battery cable.
3. Remove the positive battery cable.
E164691
4. Remove the two nuts from the clamp.
5. Remove the battery.
6. Install in the reverse order.
CHECKING THE WIPER
BLADES
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
122
Ecosport (CBY) Rayong (Thailand)/Haiduong (Vietnam), enPHI
Maintenance