Ford ECOSPORT 2014 - Hill Start Assist

WARNINGS
When doing this procedure, you will
be taking your vehicle out of P (park),
which means your vehicle can roll
freely. To avoid unwanted vehicle
movement, always fully set the parking
brake prior to doing this procedure. Use
wheel chocks if appropriate.
If the parking brake is fully released,
but the brake warning lamp remains
illuminated, the brakes may not be
working properly. See your authorized
dealer.
Use the brake shift override to move the
gearshift lever from the park position in the
event of an electrical malfunction or if your
vehicle has a dead battery.
Apply the parking brake and turn the
ignition off before performing this
procedure.
E142193
3 2
1. Apply the parking brake and switch the
ignition off before carrying out this
procedure.
2. Remove the retaining screw.
3. Remove the right side center console
side panel.
E142214
4
4. Press the brake pedal. Using a suitable
tool rotate the lever forward while
pulling the transmission selector lever
out of the P (park) position and into
the N (neutral) position.
5. Install the console cover.
6. Apply the brake pedal, start your
vehicle and release the parking brake.
HILL START ASSIST (If Equipped)
WARNINGS
The hill start assist feature does not
replace the parking brake. When you
leave the vehicle, always apply the
parking brake.
You must remain in the vehicle once
you have activated the hill start
assist feature.
During all times, you are responsible
for controlling the vehicle,
supervising the hill start assist
system and intervening, if required.
If the engine is revved excessively, or
if a malfunction is detected when the
hill start assist feature is active, the
hill start assist feature will be deactivated.
88
Ecosport (CBY) Rayong (Thailand)/Haiduong (Vietnam), enPHI
Transmission