WARNINGS
Make sure that your vehicle is on firm,
level ground with the wheels pointing
straight ahead.
Switch the ignition off and apply the
parking brake.
If your vehicle has a manual
transmission, select first or reverse
gear. If it has an automatic
transmission, select park.
Have the passengers leave your
vehicle.
Secure the diagonally opposite
wheel with an appropriate block or
wheel chock.
Do not work underneath your vehicle
when it is supported only by a jack.
Make sure that the jack is vertical to
the jacking point and the base is flat
on the ground.
Do not lay alloy wheels face down
on the ground, this will damage the
paint.
1. Loosen each wheel lug nuts one-half
turn counterclockwise, but do not
remove them.
2. Jack up your vehicle until the tire is
clear of the ground.
3. Remove the lug nuts and the wheel.
Removing and Installing a Spare
Wheel
Note: The spare wheel is located on the
rear swing gate.
Note: The locking wheel nut key is located
in the luggage compartment, under the floor
cover in the tool kit.
To Next Page
Loading...
