• If a forward gear was selected when
the system is active on, select reverse
gear.
• If reverse gear was selected when the
system is active, select a forward gear.
PARK LOCK CONTROL (If Equipped)
Park Lock Control temporarily allows you
to shift the automatic transmission
selector lever from P (Park) to N (Neutral)
after you have switched the ignition off.
This enables your vehicle to be in neutral
(N) with the ignition key removed and
reduces the vehicle battery discharge in
this state.
You can use this feature when double
parking your vehicle in neutral (N) is
required. Parking your vehicle parallel to
an already parked vehicle is double
parking.
Note: This feature can be switched on or
off in the information display. See General
Information (page 56).
Note: For vehicles without an information
display, see an authorized dealer.
When Park Lock Control is switched on
using the information display or by an
authorized dealer, carry out the following
steps to use the feature. All the steps must
be completed within 30 seconds after you
switch the ignition off in the first step and
before the driver's door is opened.
1. Select park (P) and switch off the
vehicle.
2. Remove the key.
3. Press and hold the brake pedal.
4. Select neutral (N).
Selector lever status messages will be
displayed in the information display during
this active period. Following this active
period Park Lock Control deactivates until
the next ignition On/Off cycle.
95
EcoSport (CBY) Haiduong (Vietnam)/Rayong (Thailand), DN15-19A321-GC enPHI
Transmission
To Next Page
Loading...
