Switch
position 12345678 9101112
Up, on
or +
LLLLLLLLLLLL
Middle,
neutral
or 0
MMMMMMMMMMMM
Down,
offor–
RRRRRRRRRRRR
L=left; M=middle; R=right
3. To input these positions into the
Car2U威 system, simultaneously
press all three Car2U威 system
buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U威 system by pressing and releasing the
buttons corresponding to the settings you circled.
4. After inputting switch settings, simultaneously press and release all
three Car2U威 system buttons. The indicator lights will turn on.
5. Press and hold the Car2U威
system button you would like to use
to control the garage door.
Immediately (within 1 second)
release the button once the garage
door moves. During this time the
selected button indicator light will
blink slowly. Do not release the
button until you see the garage door move. Most garage doors open
quickly. You may need to hold the button from 5–55 seconds before
observing movement of the garage door.
6. The indicator light will (begin to) blink rapidly until programming is
complete. If your garage door opener does not operate following these
steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U威 help
line at 1-866-57Car2U (1-866-572-2728).
Driver Controls
83
2011 Escape (204)
Owners Guide, 4th Printing
USA (fus)
To Next Page
Loading...
Need help?
General
