Status menus will include the remote start system as an additional key in
the total count. See the Check MyKey威 System Status section.
Note: For all vehicles with remote start installed, it is possible to
program all original vehicle keys as MyKeys威, in which case, you will
need to use your remote start system to reset all MyKeys威 as admin keys
by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow Steps 1-4 in the Clear MyKey威 section.
Troubleshooting
Condition Potential Causes
Can’t create a MyKey威 • Key in the ignition is already a
MyKey威
• Key in the ignition is the last
remaining admin key (there always
has to be at least one admin key)
• SecuriLock威 Passive Anti-Theft
System is disabled or in unlimited
mode
• Vehicle has been started using a
remote start system that is
programmed as MyKey威. Refer to
Using MyKey威 with Remote Start
Systems section.
Cannot program the MyKey威
optional settings
• Key in the ignition is a MyKey威
• No MyKeys威 are programmed to the
vehicle. Refer to Create a MyKey威
section
• Vehicle has been started using a
remote start system that is
programmed as MyKey威. Refer to
Using MyKey威 with Remote Start
Systems section.
Locks and Security
95
2011 Escape (204)
Owners Guide, 4th Printing
USA (fus)
To Next Page
Loading...
Need help?
General
