Closing the Liftgate From Outside Your
Vehicle
Press the liftgate button.
Closing the Liftgate Using the Remote
Control
Press the button twice within three
seconds. A tone sounds when the
liftgate begins to close.
Note: The tailgate also closes along with the
liftgate if the tailgate is ajar.
LIFTGATE SETTINGS
Switching the Power Liftgate On or
Off
1. From the settings menu, press vehicle.
2. Press liftgate.
3. You can switch the power liftgate on or
off on your touchscreen.
Note: When switched off, the liftgate only
unlatches and does not power open or close.
Setting the Liftgate Opening Height
1. Open the liftgate.
2. Stop the liftgate movement by pressing
the control button on the liftgate when it
reaches the desired height.
Note: Once the liftgate stops moving, you can
manually move it to the desired height.
3. Press and hold the control button on the
liftgate until a tone sounds, indicating
programming is complete.
Note: You can only use the liftgate control
button to program the height.
Note: You cannot program the height if the
liftgate position is too low.
4. The power liftgate now opens at the
programmed height. To change the
programmed height, repeat the steps.
Note: You can fully open the liftgate by
manually pushing it upward to the maximum
open position if it opens in a lower position.
Note: The system recalls the new
programmed height until you reprogram it,
even if you disconnect the battery.
Liftgate Obstacle Detection
Opening and Closing the Liftgate
The system stops and a tone sounds when
the liftgate detects an obstacle. Once you
remove the obstacle, you can continue to
operate the liftgate.
Note: To prevent accidental obstacle
detection, let the power liftgate close
completely before you enter your vehicle.
86
Expedition (TBD) Canada/Mexico/United States of America, enUSA, Edition date: 202406, DOM
Splitgate
To Next Page
Loading...
