You can shift into R (Reverse) only
by moving the gearshift from left
of 3 (Third) and 4 (Fourth) gears
before you shift into R (Reverse).
This is s special lockout feature
that protects you from accidently
shifting into R (Reverse) when you
downshift from 5 (Overdrive).
USING THE CONTROL TRAC
4WD SYSTEM (IF EQUIPPED)
Positions of the Control Trac
system
4WD AUTO — Full power
delivered to front and rear axles
for increased traction. Use this
mode for normal on-road operating
conditions such as dry road
surfaces, wet pavement, snow and
gravel.
4WD HIGH — 4WD with full
power to the rear axle and higher
continuous power level to the front
axle than 4WD AUTO. Use this
mode for severe winter or off-road
conditions such as deep snow, ice,
shallow sand.
4WD LOW — Full power to both
axles, including a lower gear ratio
for low-speed. Use this mode for
off-raod applications that require
extra power such as deep sand,
steep grades and pulling a boat out
of the water. 4WD LOW operation
is not recommended on dry
pavement.
uno_four-wd_title
uno_positions_control_trac
uno_using_control_trac_title
Driving
128
To Next Page
Loading...
