EasyManua.ls Logo

Ford EXPLORER 2019 - Page 4

Ford EXPLORER 2019
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUMENT PANEL
2
3
2
1
5
6
8
2
4
9
7
4 5
3. SERVICE ENGINE SOON LIGHT
Lights briey when you switch
on the ignition. If the light remains on
or is blinking aer starting the
engine, the On-Board Diagnostics
(OBD-II) system has detected a
problem. Drive in a moderate fashion
and have your vehicle serviced at the
first available opportunity.
4. AUTOWIPERS*
Use the rotary control to adjust the
sensitivity of the autowipers. The
autowiper system turns the wipers
on only when moisture is present on
the windshield.
A low sensitivity means the
wipers turn on when the system
detects a large amount of moisture
on the windshield.
A high sensitivity means the
wipers turn on when the rain
sensor detects a small amount of
moisture on the windshield.
Autowipers default to on and remain
on until you switch them o in the
information display.
NOTE: Make sure you switch this
feature o before entering a car wash.
5. STEERING WHEEL CONTROLS
VOL + or Press to increase or
decrease volume levels.
or Press to access
the previous or next
media selection.
Press to silence the
current media.
Press to access
voice recognition.
Press to end a phone call.
Press to access phone
mode or to answer a
phone call.
6. KEYLESS STARTING*
You can start your vehicle by pressing
the START STOP button while fully
pressing down on the brake pedal.
Press the button again, without
applying the brake, to switch the
engine o. If you leave your vehicle
idling for an extended period of time,
the engine shuts down automatically.
Before this happens, a message
appears in the information display,
allowing you time to override the
shutdown feature. If you try to leave
the vehicle when it is still on, the horn
will sound twice.
NOTE: A valid key must be inside the
vehicle for the ignition to start.
7. 180 DEGREE CAMERA*
The system consists of front and
rear cameras.
The system:
Allows you to see what is directly
in front of or behind your vehicle.
Provides cross trac view in front of
and behind your vehicle.
Provides visibility during
parking maneuvers.
Press the camera button to
toggle between dierent views.
See the Parking Aids chapter of your
Owners Manual for details.
NOTE: The front view camera switches
o if your vehicle speed exceeds
6 mph (10 km/h). You need to switch
the system back on by pressing the
camera button
once.
8. HAZARD CONTROL
9. CLIMATE CONTROLLED
FRONT SEATS*
Press the or repeatedly to cycle
through the various modes and o.
More lights indicate warmer or cooler
settings. See the Seats chapter in your
Owners Manual for details.
1. ADAPTIVE CRUISE CONTROL*
Adaptive Cruise Control adjusts your speed to
maintain a set distance between your vehicle and
the vehicle in front of you in the same lane.
You can select from one of four gap settings by
pressing the gap controls on the steering wheel.
Refer to the Cruise Control chapter in your
Owners Manual for safety information, more
details and limitations.
2. INFORMATION DISPLAYS*
Provides information about various systems on
your vehicle. Use the le-hand controls to choose
and confirm settings and messages. See the
Information Displays chapter in your Owners
Manual for more information.
Use the right-hand controls to choose and
confirm audio, phone and navigation* settings.
See the SYNC 3 chapter in your Owner’s Manual
for more information.
*if equipped *if equipped

Related product manuals