Ford EXPLORER 2024 - Reverse Wipe; Checking the Wiper Blades; Replacing the Front Wiper Blades

REVERSE WIPE
WHAT IS REVERSE WIPE
Reverse wipe turns on the rear window
wiper when you shift into reverse (R) and
the windshield wipers are on.
REVERSE WIPE SETTINGS
1. From the settings menu, press Vehicle.
See Center Display (page 457).
2. Press Wipers.
3. Switch Rear wiper on or off.
CHECKING THE WIPER
BLADES
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
REPLACING THE FRONT
WIPER BLADES
Make sure your vehicle is off before
beginning this procedure.
Note: Do not manually move the wiper
arms when the vehicle is on or in accessory
mode, this could damage the wiper motor.
E129990
1. Lift the wiper arm and then press the
wiper blade locking buttons together.
Note: Do not hold the wiper blade to lift the
wiper arm.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
2. Slightly rotate the wiper blade.
3. Remove the wiper blade.
4. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
102
Explorer (CTW) Canada/Mexico/United States of America, enUSA, Edition date: 202401, DOM
Wipers and Washers