2. Rotate the headlamp control to the autolamp position.
3. Rotate the headlamp control to the off position.
4. Turn the vehicle on.
5. Turn the vehicle off.
6. Turn the headlamp control to the autolamp position (the headlights
should turn on).
7. Turn the headlamp control to the off position when the desired delay
time (up to three minutes) has been reached.
Fog lamp control
The fog lamps will only operate with
the parking lamps or headlamps
activated.
• Press the top of the control,
located on the instrument panel,
to activate the fog lamps.
• Press the top of the control again
to deactivate the fog lamps
Note: The fog lamps will not
operate if the high beams are
activated.
Note: The fog lamp indicator will illuminate when the fog lamps are
activated.
High beams
Pull the lever fully past the detent
to activate. Pull the lever fully again
to deactivate.
Lights
72
2012 Explorer (exp)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
