Ford F-150 2002 - D2 Solenoid Functional Test

Active Command Modes
Output State Control (OSC)
Trans-Bench Mode
 Does the vehicle enter the Trans-Bench Mode?
Yes
REMAIN in Trans-Bench Mode. GO to D2 .
No
REPEAT procedure to ENTER Trans-Bench Mode. If vehicle did not enter OSC, REFER to
Powertrain Control/Emissions Diagnosis (PC/ED) manual for diagnosis of PCM or NGS.
D2 SOLENOID FUNCTIONAL TEST
Monitor pressure gauges.
Parameter; PCx
Select EPC.
Select value - 15, 30, 45, 60, 75 or 90 psi.
Press "SEND".
Select another value "0-90 psi".
Press "SEND".
XXX
Press "SEND".
 Does the pressure reading match the commanded pressure?
Yes
CLEAR DTCs.
No
GO to D3.
D3 CHECK FOR BATTERY VOLTAGE
Transmission Harness Connector
Visually inspect all wires and connectors for damage.
Measure the voltage between solenoid body harness connector pin 11 harness side and
ground.
Page
21
of
33
2002 F
-
150 Workshop Manual
9/17/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS21/~MUS~LEN/19/S
...