FEATURE SETUP
POSITION YOUR VEHICLE
AND TRAILER
Read and follow all of these steps carefully to get the best results.
• • Hitch the trailer to your vehicle and connect the electrical wiring harness.
Check to make sure that the wiring is working.
• • Park your vehicle and hitched trailer on a level surface.
• • Make sure that the trailer and vehicle are in line with each other. You can do
this by putting the transmission in drive (D) and pulling straight forward.
SETUP OPTIONS
Your trailer can be set up with a sticker that is provided with this guide. Follow
the instructions in the next section of this guide to place your sticker and set
up your trailer. For information on how to use a sensor instead of a sticker, see
your Owner's Manual.
ONE-TIME SETUP
Once you input your trailer’s information into the touchscreen, it is stored for
easy recall. That way, when you want to use the Pro Trailer Backup Assist with
Trailer Reverse Guidance system to help you back your trailer into your desired
position, you can choose it from the touchscreen. You do not have to run
through this setup again unless you want to add another trailer. You can store
information for up to 10 trailers within this feature.
5
6
To Next Page
Loading...
