FEATURE SETUP
OUTSIDE THE VEHICLE
• • Take the sticker placement card and the sticker from the back of this guide, and a tape measure, and walk back to the trailer.
• • Place the sticker in the green zone as indicated in the diagram on the following page.
• • Confirm that the sticker is visible using the touchscreen. An assistant can remain inside the vehicle to help you do this.
STICKER PLACEMENT TIPS
• Perform sticker placement when temperatures are above 32° F (0° C).
• Put the sticker on a flat, dry, clean horizontal surface.
• Using a tape measure, find a place to put the entire sticker in the range as shown below:
– Within the green zone.
– Between 4 - 19 in (10 - 48 cm) from the trailer ball hitch.
• Make sure no hardware obstructs the view from the camera to the sticker such as a jack handle or wiring.
• Place the sticker.
STICKER PLACEMENT DIAGRAM
Note: Place the entire sticker within the green zone. Once you place the sticker,
you cannot move it. Do not attempt to reuse stickers. Use a new sticker.
If you cannot find a location that meets the sticker requirements, the sensor
is recommended.
PLACING THE STICKER
4 in
10 cm
4 in / 10 cm
19 in
48 cm
4 in
10 cm
4 in / 10 cm
A-Frame Trailer Tongue Straight Trailer Tongue
Top Views
Yes
No
19 in / 48 cm
9
10
To Next Page
Loading...
