Fuel Injection Supply Manifold—Fuel Injection
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are
always present and may be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the fuel lines or fuel
system components, the fuel system pressure must be relieved. Failure to follow these instructions may result in personal injury.
All engines
1. Disconnect the battery ground cable (14301). For additional information, refer toSection 414-01.
2. Relieve the fuel pressure. For additional information, refer toSection 310-00A.
3. Partially drain the cooling system. For additional information, refer toSection 303-03A or Section 303-03B.
4. Remove the power steering reservoir bracket.
1. Remove the bolts.
2. Position the power steering reservoir bracket out of the way.
5. Remove the accelerator control splash shield.
1. Remove the bolts.
2. Remove the accelerator control splash shield.
6. Disconnect the fuel pressure regulator valve vacuum hose.
7. CAUTION: After disconnecting, plug the fuel lines to prevent leakage.
Disconnect the fuel lines. For additional information, refer toSection 310-00A.
8. Disconnect the eight ignition coil electrical connectors.
SECTION 303-04B: Fuel Charging and Controls — 4.6L (2V) and 5.4L (2V) 2001 F-150 Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 06/19/2000
Material
Item Specification
XO-10W20-QSP or DSP clean engine oil or equivalent
—
WSS-M2C153-H
http://www.fordtechservice.dealerconnection.com/pubs/content/
To Next Page
General
