To be sure your vehicle is ready to operate, conduct a pre-trip inspection
at the beginning of each work period. Follow the steps listed in this
section to ensure a proper vehicle inspection procedure. The pages in
this section may be produced locally and used on a regular basis.
VEHICLE INSPECTION INFORMATION
Note: Always make sure the parking brake is applied before starting the
engine.
Engine compartment (with engine stopped)
Engine oil Use the dipstick to verify the oil level is in the
proper operating range.
Engine coolant Look through the plastic reservoir or the clear
sight glass on the reservoir (depending upon
vehicle equipment) and verify the coolant level is
within the proper operating range as marked on
the reservoir. Do not remove pressure cap
until the coolant has cooled.
Power steering
fluid
Verify that the fluid level is in the proper
operating range. Refer to Power steering fluid in
the Maintenance and Specifications chapter.
Brake fluid Remove the master cylinder caps and inspect the
fluid level. The full mark is at the bottom of the
opening of the fluid ports.
Hydraulic clutch
fluid
Remove the cap and inspect the fluid level. The
full mark is at the step of the reservoir.
Belts (fan,
alternator, water
pump and A/C
compressor)
Inspect for glazing, fraying or cracking. There
should be no more than 5-7 cracks per rib, per
inch (2.5 cm).
Fluid leaks Inspect for signs of fluid puddles, dripping fluid
on the ground under the engine or the underside
of the engine.
HVAC air inlet Inspect for debris that may have collected on the
HVAC air inlet grille or inside the exterior module
as this may cause reduced system performance.
Vehicle Inspection Guide
10
2012 F-650/750 (f67)
Supplement, 2nd Printing
USA (fus)
To Next Page
Loading...
