4. Partially tighten the wheel nuts in the
sequence shown.
5. Lower the vehicle and remove the
jack.
6. Fully tighten the wheel nuts in the
sequence shown. See Technical
specifications (page 145).
7. Install the hub cap or cover using the
ball of your hand.
WARNING
Have the wheel nuts checked for
tightness and the tyre pressure
checked as soon as possible.
Note:
If the spare wheel is different in size
or construction to the road wheels, have
this replaced as soon as possible.
TYRE REPAIR KIT
Your vehicle may not have a spare tyre.
In this case it will have an emergency tyre
repair kit that can be used to repair one
flat tyre.
The tyre repair kit is located in the spare
wheel well.
General information
WARNINGS
Depending on the type and extent
of tyre damage, some tyres can
only be partially sealed or not sealed
at all. Loss of tyre pressure can affect
vehicle handling, leading to loss of vehicle
control.
Do not use the tyre repair kit if the
tyre has already been damaged as
a result of being driven under
inflated.
Do not try to seal damage other
than that located within the visible
tread of the tyre.
Do not try to seal damage to the
tyre’s sidewall.
The tyre repair kit seals most tyre
punctures [with a diameter of up to six
millimetres (1/4 inch)] to temporarily
restore mobility.
Observe the following rules when using
the kit:
140
Wheels and tyres
To Next Page
Loading...
