2. Start the engine.
STARTING A DIESEL ENGINE
Vehicles With Manual
Transmission
Note: Do not touch the accelerator pedal.
Note: Releasing the clutch pedal while the
engine is starting will stop the engine
cranking and return to ignition on.
1. Fully depress the clutch pedal.
2. Start the engine.
Vehicles With Automatic
Transmission
Note: Do not touch the accelerator pedal.
Note: Releasing the brake pedal while the
engine is starting will stop the engine
cranking and return to ignition on.
1. Move the transmission selector lever to
position P or N.
2. Fully depress the brake pedal.
3. Start the engine.
AUTO-START-STOP
Using Start-Stop
Note: The system is on by default. To switch
the system off, press the switch in the
instrument panel. The system will only be
switched off for the current ignition cycle. To
turn it on, press the switch again.
To stop the engine
1. Stop your vehicle.
2. Move the gear lever to the neutral
position.
3. Release the clutch pedal.
4. Release the accelerator pedal.
The system may not shut down the engine
under certain conditions, for example:
• To maintain the interior climate.
• Low battery voltage.
• The outside temperature is too low or
too high.
• The driver's door has been opened.
• Low engine operating temperature.
• Low brake system vacuum.
• If a road speed of 3 mph (5 km/h) has
not been exceeded.
• The driver's safety belt has not been
fastened.
To re-start the engine
Note: The gear lever must be in the neutral
position.
Depress the clutch pedal.
The system may automatically restart the
engine under certain conditions, for
example:
• Low battery voltage.
• To maintain the interior climate.
REFUELING
1. Press the flap to open it. Open the flap
fully until it engages.
12
Fiesta (CCN) , CG3583en enGBR, Edition date: 02/2014, None
To Next Page
Loading...
