GENERAL INFORMATION
This section describes the functions and
features of the Bluetooth mobile phone
and voice control system.
The section covers the following variations:
• a mobile phone with a mobile phone
cradle without voice control
• a Bluetooth and voice control system
with a mobile phone cradle
• a Bluetooth and voice control system
without a mobile phone cradle.
The Bluetooth mobile phone part of the
system provides interaction with the audio
or navigation system and your mobile
phone. It allows you to use the audio or
navigation system to make and receive
calls without having to use your mobile
phone.
The voice control part of the system can
be used to control:
• mobile phone calls
• audio system functions
• vehicle climate control functions.
Note: The mobile phone does not switch
off immediately after the ignition key is
turned off: the power down delay is preset
to 10 minutes. The time period can be
adjusted to between 0 and 60 minutes.
This, depending on your mobile phone, can
be achieved by creating a phonebook entry
on your mobile phone with the name Timer
and the required delay as it's number.
If the Bluetooth and voice control is used
for an extended period of time when the
vehicle is stationary, make sure that the
engine is running to avoid draining the
battery
TELEPHONE SETUP
Requirements for cradle
connection
Your phone must be fitted in a mobile
phone holder before it can be used as a
cradle phone with your handsfree/voice
control system. You will be able to
purchase the correct holder for your phone
from your dealer.
Placing your phone in the cradle
Note: Your phone must be fitted in a mobile
phone holder to allow you to connect the
phone to the cradle.
Connect your phone to the cradle.
1. Place the base of the phone in the
cradle connection.
Note: Make sure that the phone is pushed
fully rearwards in the cradle.
2. Push the phone downwards until a
click is heard.
To Next Page
Loading...
