Fax
Making a phone an active phone
When using the system for the first time,
no phone is connected to the system.
After switching on the ignition the cradle
phone and the Bluetooth phone are
recognized differently by the system.
Bluetooth phone
After bonding a Bluetooth phone to the
system, this becomes the active phone.
For further information refer to the phone
menu.
However, in some cases the Bluetooth
phone has to be activated by pressing the
appropriate station button on the audio or
navigation unit.
Turning the ignition back on again, the last
active phone is picked up by the system.
Bond another Bluetooth phone
Note: Before another Bluetooth phone can
be bonded, the existing active Bluetooth
connection has to be deactivated by the
mobile phone.
Bond a new Bluetooth phone as described
in the requirements for a Bluetooth
connection.
Phones stored in the system are accessible
by using the phone list on the audio or
navigation unit.
Note: If six (five Bluetooth phones for
cradle phone system) Bluetooth phones
have been bonded, one of these has to be
deleted in order to bond a new phone.
Cradle phone
With your phone fitted in the mobile phone
cradle this does not automatically become
the active phone.
In these cases refer to Changing the
active phone in the appropriate section
which describes the system fitted to your
vehicle.
BLUETOOTH SETUP
Before you can use your telephone with
your vehicle it must be bonded to the
vehicle telephone system.
156
Telephone
To Next Page
Loading...
