In order to re-programme the function,
press and hold the unlock and lock buttons
simultaneously for at least four seconds
with the ignition switched off. The direction
indicators will flash twice to indicate that
the unlocking function has been
successfully re-programmed.
Pressing and holding both buttons
simultaneously for at least four seconds
again will change the function back.
CHANGING THE REMOTE
CONTROL BATTERY
Make sure that you dispose of
old batteries in an
environmentally friendly way.
Seek advice from your local authority
regarding recycling.
If the range of the transmitter in the key
decreases gradually, the battery (type 3V
CR 2032) should be replaced.
• Carefully separate the transmitter unit
from the key using a flat object (e.g. a
screwdriver) at the recess on the back.
• Carefully prise out the battery with the
flat object. Fit the new battery between
the contacts with the + sign facing
downwards. Reassemble the
transmitter unit in reverse order.
• Open the transmitter unit by separating
the retaining clips on the sides with the
flat object.
• Carefully prise out the battery with the
flat object. Fit the new battery between
the contacts with the + sign facing
downwards. Reassemble the
transmitter unit in reverse order.
26
Keys and Remote Controls
To Next Page
Loading...
