The rain sensor will continuously measure
the amount of water on the windscreen
and adjust the speed of the front wipers
automatically (single wipe, intermittent,
normal or high speed wiping).
The sensitivity of the rain sensor is set
using the rotary control:
1 = High sensitivity: The wipers will wipe
even if only a small amount of water is
detected on the windscreen.
6 = Low sensitivity: The wipers will only
wipe when a larger amount of water is
detected on the windscreen.
WINDSCREEN WASHERS
WARNING
Do not operate the windscreen
washer for more than 10 seconds or
when the reservoir is empty.
REAR WINDOW WIPER AND
WASHERS
Intermittent wiping
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activated
automatically when selecting reverse gear,
if
• the rear wiper is not already switched
on,
• the wiper lever is in position C, or D
• in position B and the front wipers are
operating.
The rear wiper will follow the front wiper
interval (at intermittent or normal speed).
34
Wipers and Washers