CAUTION
Do not pull the bumper more than 10
mm from its original position.
3. Carefully pull the bumper towards the
front of the vehicle and remove the
screw.
4. Disconnect the electrical connector
and remove the headlamp.
CAUTION
When fitting the headlamp, take care
not to damage the locating points.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the fixing points.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
CAUTIONS
Do not touch the glass of the bulb.
Only fit bulbs of the correct
specification. See Bulb
Specification Chart (page 46).
Note: The following instructions describe
how to remove the bulbs. Fit replacement
in the reverse order unless otherwise stated.
Headlamp main and dipped beam
1. Remove the headlamp. See
Removing a Headlamp (page 41).
2. Remove the cover.
3. Disconnect the electrical connector.
4. Release the clip and remove the bulb.
Side lamps
1. Remove the headlamp. See
Removing a Headlamp (page 41).
42
Lighting
To Next Page
Loading...
