2. Release the brake pedal and press the
accelerator pedal.
Stopping
1. Release the accelerator pedal and
press the brake pedal.
2. Apply the parking brake.
Kickdown
Press the accelerator pedal fully to select
the next highest gear for optimum
performance. Release the accelerator
pedal when you no longer require
kickdown.
AUTOMATIC TRANSMISSION
- VEHICLES WITH: 4-SPEED
AUTOMATIC TRANSMISSION
(4F27E)
Selector lever positions
ParkP
ReverseR
NeutralN
DriveD
2nd Gear2
1st Gear1
WARNING
Apply the brakes before moving the
selector lever and keep them applied
until you are ready to move off.
Note: A cold engine has a higher idle speed.
This will increase the tendency for your
vehicle to creep when you have selected a
drive gear.
Press the button on the selector lever to
select reverse and park.
The selector lever position will be shown
in the information display.
Park
WARNINGS
Select park only when your vehicle
is stationary.
Apply the parking brake and select
park before leaving your vehicle.
Make sure that the selector lever is
latched in position.
Note: An audible warning will sound if you
open the drivers door and you have not
selected park.
In this position, power is not transmitted
to the drive wheels and the transmission
is locked. You can start the engine with the
selector lever in this position.
Reverse
WARNING
Select reverse only when your vehicle
is stationary and the engine is at idle
speed.
79
Transmission
To Next Page
Loading...
