Ford Fusion 2011 - Stability Control; Principle of Operation; Using Stability Control

PRINCIPLE OF OPERATION
Electronic stability programme
(ESP)
WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
E72903
A
A
A
B
B
B
B
Without ESPA
With ESPB
The system supports stability when the
vehicle starts to slide away from your
intended path. This is performed by braking
individual wheels and reducing engine
torque as needed.
The system also provides an enhanced
traction control function by reducing
engine torque if the wheels spin when you
accelerate. This improves your ability to
pull away on slippery roads or loose
surfaces, and improves comfort by limiting
wheel spin in hairpin bends.
Stability control (ESP) warning lamp
While driving, it flashes during activation
of the system. See Warning Lamps and
Indicators (page 50).
Emergency brake assist
WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
The system will detect when you brake
heavily by measuring the rate at which you
press the brake pedal. It will provide
maximum braking efficiency as long as you
press the pedal. The system can reduce
stopping distances in critical situations.
USING STABILITY CONTROL
E94885
Press and hold the switch for one second.
The switch will illuminate.
Press the switch again to turn the system
on. The system will be switched on
automatically every time you switch the
ignition on.
For item location: See At a Glance (page
8).
83
Stability Control