5. Lift the outer side of the headlamp
and remove it.
Note:
When fitting the headlamp,
make sure that you reconnect the
electrical connector properly.
Note:
When fitting the headlamp,
make sure that you fully engage the
headlamp in the lower fixing point.
Note:
When fitting the headlamp,
make sure that the front screw is
located in the headlamp moulding
before you install it.
Note:
When fitting the headlamp,
tighten the front screw first and then
the rear screw.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition
off.
Let the bulb cool down before
removing it.
Have Xenon bulbs changed by
a properly trained technician.
There is a risk of electric shock.
CAUTIONS
Do not touch the glass of the
bulb.
Only fit bulbs of the correct
specification. See Bulb
specification chart (page 72).
Note:
The following instructions
describe how to remove the bulbs.
Fit replacements in the reverse order
unless otherwise stated.
Headlamp
Note:
Remove the covers to gain
access to the bulbs.
To Next Page
Loading...
