Note:
When the mirrors are
operated often during a short period
of time, the system may become
inoperable for a period of time to
prevent damage due to overheating.
Reverse mirror dipping
Depending on the selected mirror
position (A or C), the relevant exterior
mirror will dip whenever you select
reverse gear, giving you a view of the
kerb.
When you first use this feature, the
mirrors will dip to a preset position.
You can programme the degree of
dipping using the following sequence:
Note:
You can disable this feature
by leaving the electric exterior mirror
selector switch in position B.
The exterior mirrors will return to the
original position:
•
If the vehicle speed exceeds 10
km/h (6 mph).
•
Approximately 10 seconds after
reverse gear has been
disengaged.
•
If the electric exterior mirror
selector switch is returned to
position B.
Passive setting
1. Turn the ignition on. Do not start
the engine.
2. Select the desired exterior mirror
(A or C).
3. Select reverse gear, the selected
exterior mirror will adjust to a
preset position.
4. Adjust the mirrors to the required
dipped position.
5. Disengage reverse gear.
The settings will be stored
automatically.
Active setting
1. Turn the ignition on. Do not start
the engine.
2. Select the desired exterior mirror
(A or C).
3. Select reverse gear, the selected
exterior mirror will adjust to a
preset position.
4. Adjust the mirror to the required
dipped position.
5. Press and hold the desired
pre-set button until a single chime
sounds to confirm. See Memory
function (page 142).
INTERIOR MIRROR
To Next Page
Loading...
