15
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
YOUR CAR
Setting the clock (Hour)
With this function it is possible to set
the clock.
To set the required unit proceed as
follows:
– briefly press button MENU
ESC,
“hours” will flash on the display;
– press button + or – for setting;
– briefly press button MENU ESC,
“minutes” will flash on the display;
– press button + or – for setting;
– briefly press button MENU ESC to
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
Adjusting the buzzer volume
(Buzz)
This function is used to adjust the
volume of the buzzer triggering in the
event of failure/warning indications and
when MENU
ESC + and – buttons are
pressed.
To adjust the desired volume proceed
as follows:
– briefly press button MENU ESC , the
display will show the wording (bUZZ);
– press button + or – to select the
required volume (volume can be
adjusted according to 8 levels).
– briefly press button MENU
ESC to
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
Setting the speed limit (Speed)
With this function it is possible to set
the car speed limit (km/h or mph),
when this limit is exceeded the driver is
immediately alerted (see section
“Warning lights and messages”).
To set the speed limit, proceed as
follows:
– briefly press button MENU
ESC , the
message (SPEED) and the previously set
unit (km/h) or (mph) will appear on the
display;
– press button + or – to select speed
limit activation (On) or deactivation
(OFF);
– when the function is activated (On)
pressing buttons + or – select the
speed limit and press MENU
ESC to
confirm selection.
Note Selection is possible between 30
and 200 km/h, or 20 and 125 mph
depending on the selected unit, see
paragraph “Unit of measure”. The
setting will increase/decrease by five
units each time button +/– is pressed.
Hold button +/– pressed to
increase/decrease the setting rapidly.
Complete the setting by briefly pressing
the button when the required setting is
approached.
– briefly press button MENU
ESC to
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
To cancel the setting, proceed as
follows:
– briefly press button MENU ESC:
(On) will flash on the display;
– press button –: (Off) will flash on the
display;
– briefly press button MENU ESC to
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
To Next Page
Loading...
