49
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
YOUR CAR
BONNET
Opening fig. 46-47-48
Proceed as follows:
❒
pull lever A in the direction of the
arrow;
❒
move to the right the lever B as
shown in figure;
❒
lift the bonnet and at the same time
release the support rod C from its
locking device D, then insert the end
of the rod in the seat E of the engine
hood (bigger hole) and push to safety
position (smaller hole), as shown in
figure.
Rear seat repositioning
Raise the seat backrests and push them
back until hearing the locking click of
both retainers.
Position the seat belt buckles up.
IMPORTANT When returning the
backrest to the position of use, make
sure it is correctly fastened and you
hear the lock click.
Make sure the backrest is properly
secured at both sides to prevent it
moving forward in the event of sharp
braking causing injuries to passengers.
REMOVING THE REAR
PARCEL SHELF
To remove the rear shelf, release it from
its two side pins and pull it out.
fig. 46
KA00038m
If the supporting rod is not
positioned correctly the
bonnet may fall violently. Perform
these operations when the car is
stationary only.
WARNING
fig. 47
To Next Page
Loading...
