Using the manual lumbar support (if equipped)
The lumbar control is located on the
inboard side of the driver’s seat.
Move the control up or down to
adjust lumbar support.
Adjusting the power seats (if equipped)
The power seat controls are located on the outboard side of the seat.
Never adjust the driver’s seat or seatback when the vehicle is
moving.
Always drive and ride with your seatback upright and the lap
belt snug and low across the hips.
Reclining the seatback can reduce the effectiveness of the seat’s
safety belt in the event of a collision.
Move the control up or down to move the seat up and down.
• 6 way (driver seat)
Slide the control forward or backward to move the seat forward or
backward.
Seating and Safety Restraints
119
To Next Page
Loading...
Need help?
General
