Ford Mustang 2002 - Separate and Position Engine Harness; Disconnect Water Temperature Indicator Sender; Remove Water Outlet Connector; Remove Water Thermostat and O-ring

36. Separate the engine harness and position it out of the way.
37. Disconnect the water temperature indicator sender.
38. Remove the water outlet connector.
39. Remove the water thermostat and the O-ring.
 Inspect the O-ring and discard if necessary.
40. NOTE: The gaskets are reusable if not damaged.
Remove the bolts in the sequence shown, remove the intake manifold and gaskets.
Page
7
of
14
2002 Mustang Workshop Manual
7/15/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2B/~MUS~LEN/19/S
...