Ford Mustang 2002 - Intake Manifold Installation; Install Intake Manifold and Gaskets; Install Water Thermostat and O-ring; Install Water Outlet Adapter

Installation
1. Install the intake manifold and gaskets, tighten the bolts in the sequence shown.
2. NOTE: The O-ring is to be installed on the top of the thermostat.
Install the water thermostat and the O-ring.
 Install a new O-ring as necessary.
3. Install the water outlet adapter.
4. Connect the water temperature indicator sender.
5. Position the engine harness and attach to the intake manifold in two locations.
Page
8
of
14
2002 Mustang Workshop Manual
7/15/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2B/~MUS~LEN/19/S
...