AUDIO SYSTEMS
1
6
7
3
10
8
54
2
9
1 POWER / VOLUME
Press to turn ON or OFF. Turn to increase or decrease
volume. If the volume is set above a certain level and the
ignition is turned off, the volume will come back on at a
“nominal” level when the ignition switch is turned back on.
2 LOAD BUTTON
Press to begin the CD load sequence. When the radio
prompts to select a slot, use the preset button to select the
desired slot to load the CD. When the radio prompts to load
a CD, press and hold to auto load up to 6 CDs in sequence.
3 CD BUTTON
Press to enter CD mode. If a CD is already loaded into
the system, the CD play will begin where it last ended.
4 SEEK BUTTONS
Press to access the previous or next strong station
or track. Also use it in menu mode to select various
settings.
5 SCAN BUTTON
Press for a brief sampling of radio stations or CD tracks.
Press again to stop scanning.
6 UP/DOWN ARROWS
Press to manually move up or down the radio
frequency. Also, use in menu mode to adjust the
quality of different modes.
7 MENU BUTTON
Use the MENU button to cycle through the possible modes
(Bass, Treble, Fade, and Balance, among others). Then
use SEEK or up/down arrows to adjust the setting. Fade
will adjust audio between the front and rear speakers and
Balance adjusts between left and right speakers.
8 SETTING MEMORY PRESETS
To set a station: Select frequency band AM/FM; tune
to a station, press and hold a preset button until the
display reads PRESET SAVED.
9 MP3 TRACK / FOLDER MODE
Available only on MP3 discs in CD mode. Press to
go into MP3 folder mode. Press again to access
previous/next folder.
10 CD REWIND / FAST FORWARD
Press REW to manually reverse within a CD track.
Press FF to manually advance within a CD track.
To Next Page
Loading...
