Ford Ranger 2001 - Transfer Case and Clutch Line Disconnection; Transmission Support and Isolator Nuts

12. Remove the bolts retaining the catalytic converter to the muffler. Discard the exhaust converter outlet gasket.
13. While supporting the exhaust inlet crossover pipe and the catalytic converter assembly, remove the exhaust hanger from the insulator. Position the exhaust assembly aside.
14. On 4-wheel drive vehicles, remove the transfer case. For additional information, refer to Section 308-07B.
15. Using the special tool, disconnect the clutch hydraulic line from the clutch slave cylinder.
16. WARNING: Secure the transmission to the jack with a suitable safety strap. Failure to follow these instructions may result in personal injury.
Using a suitable transmission jack, support the transmission. Secure the transmission to the jack with a suitable safety strap.
17. Loosen, but do not remove the nuts retaining the transmission insulator to the crossmember.
Page
3
of
4
2001 Ranger Workshop Manual
8/25/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS1L/~MUS~LEN/19/S
...