Ford Ranger 2007 - Event Data Recording

 Is any voltage present?
K11 CHECK FOR CORRECT SJB OPERATION
 Disconnect all the SJB connectors.
 Check for:
 corrosion
 damaged pins
 pushed-out pins
 Connect all the SJB connectors and make sure they seat correctly.
 Operate the system and verify the concern is still present.
 Is the concern still present?
Yes
INSTALL a new SJB. REFER to Section 419-10. TEST the
system for normal operation.
No
The system is operating correctly at this time. The concern
may have been caused by a loose or corroded connector.
Page
7
of
7
2007 Ranger Workshop Manual
6/20/2011
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS7L/~MUS~LEN/20/S
...